You will need the following:
- some mantic's restic fleabag riders
- a mantic's metal mawbeast (you actually need just one and you can always take one from a friend since it's just needed for the mold)
- some temporary mold material like Instantmold
- some green stuff or similar modelling putty
Use the back of the metal mawbeast and make a mold out of it (you need just a mold of the furry back not the whole model). In order to do this you have to warm up the Instantmold into how water (be careful!) press it on the mawbeast's back and wait for it to cool down.
Before assembling the fleabag riders you have to cut the legs from the ride, you can use a plastic cutter and then take out the small pieces with something sharp. This will leave a huge flat gap on the fleabag's backs that will be filled in next step.
Then you glue together the two halves of the ride, the tongue and for some rides the separate paw. You also might want to glue them on the base at this point (or you can do it later, as you prefer)
Fun with the green stuff
Now it's time to make the furry back's, make sure that the mold is wet (it will be easier to take out the green stuff) then press some green stuff in the mold. Turn the mold over and press it on the fleabag back assembled in previous step. Make sure that the green stuff stuck onto the model and carefully take away the mold. The picture below shows the final result.
nice one! :)
Post a Comment